I keep getting an error and cannot get this to work.

[cbatten01]

I have tried everything and keep getting this error. I think the codes were changed but the wiring diagram was not. I am new to this.

ets Jan 8 2013,rst cause:4, boot mode:(3,6)

wdt reset
load 0x4010f000, len 3584, room 16
tail 0
chksum 0xb0
csum 0xb0
v5d3af165
~ld
Starting...

[DotNetDann]

That message is your ESP chip resetting due to the code loop not running. (Watch dog timer is resetting the board) All pinouts are set by you in the auth.h file. Check these. I would disable all but one garage door first and try that and then re-enable others as you go. I have actually moved off this and onto ESPHome If you are starting out then this may be more friendly. I have my config for esphome here - https://github.com/DotNetDann/esphome-config/blob/master/garage_door.yaml I hope that helps Dan

…

On Wed, 5 Aug 2020 at 15:48, cbatten01 ***@***.***> wrote: I have tried everything and keep getting this error. I think the codes were changed but the wiring diagram was not. I am new to this. ets Jan 8 2013,rst cause:4, boot mode:(3,6) wdt reset load 0x4010f000, len 3584, room 16 tail 0 chksum 0xb0 csum 0xb0 v5d3af165 ~ld Starting... — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#3>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AA24C7YG4GKEV2OTLSPCXK3R7DXCRANCNFSM4PVDOCBQ> .