Ender 6 - Z-Offset Value Issues on LCD Display

[Tw0bit]

Description

Ender 6 (https://github.com/InsanityAutomation/Marlin/blob/CrealityDwin_2.0/Hex%20Files/firmware_Ender6_DW7.4.bin.zip):

• Z-Axis Compensation on Print Screen always shows 0 even when you tap + or -
• Manual Mesh process shows only 1 decimal value (i.e. 0.2) but the steps are in 0.025 - so 4 steps to change the shown value

Steps to Reproduce

Print Interface

1. Print a file, adjust the Z-Axis Compensation - always shows 0

Level Interface

1. Start the Manual Mesh Process
2. The shown value box is 1 decimal value but require 3 to level with the 0.025 steps

Expected behavior: [What you expect to happen]
Value shows as epected

Actual behavior: [What actually happens]
Value not showing

[Tw0bit]

How would i make/save a +0.08mm offset on this firmware? Each print i have to adjust Z by 4 + clicks.

[SplinMS]

Z-Axis Compensation on Print Screen always shows 0 even when you tap + or -

[burockoz]

the z offset value is limited to -9, no matter what I do, I always stay 4-5mm away from the bed.