KP3s KINGROON CURA 5.12.0 Fail print at 50%

[MoldesLs]

Cura Version

5.12.0

Operating System

Windows 11

Printer

KP3s

Reproduction steps

Falla la impresión al 48% de avance, varios intentos con distintos perfiles y continua la falla.

Actual results

Se cambiaron perfiles de impresión, continua la falla.

Expected results

Porfavor arreglen los códigos para la KP3s KINGROON

Add your .zip and screenshots here ⬇️

Molde choc 8 pz.zip

[GregValiant]

Thanks for the report.
The gcode you provided is correct and the model is complete. If the printer is quitting before it has completed the print then the problem is with the printer.

If you are printing via the SD card, those cards can become corrupt and part of a gcode file can be written to the corrupt memory sectors. The print will start OK, but quit before it should. Formatting the card often fixes the problem.

Looking at the gcode preview in Cura, and also at your print in the photo, it appears that you might be getting heat-creep and a clog might be developing in the hot end causing extrusion to stop. Those types of clogs can occur after printing for some amount of time. You would need to disassemble and clean the hot end and mybe trim the bowden tube back 5 or 6mm and re-install it.

Let us know if either of those suggestions works.