i have a 10 inch drone, previously flashed in betaflight and esc configurator with Bluejay 0.21. i have my 4in 1 esc oriented by 180 degrees pointed on the front, so the battery cable and capacitor are in the front of my quad. So motor 1 is on the left front and the fourth is on the rear right of the drone. in iNav i'm trying to re map the motors via mixer Wizard and select props out config. After doing that the ESC keeps beeping (not continosly but once after time) and the motors aren't in right config of props out, so the motor in the front left is props out but the one in front right spin props in, so in the rear.
I also noticed that after the flash in iNav esc configuratore doesn't read my ESC anymore (it says ESC 1,2,3,4 failed to read) this didn't happen with betaflight flashed.
my specs: ESC DAKEFPV 4 in 1 70A, FC DAKEFPV H743, motors R3115 900KV.
i have a 10 inch drone, previously flashed in betaflight and esc configurator with Bluejay 0.21. i have my 4in 1 esc oriented by 180 degrees pointed on the front, so the battery cable and capacitor are in the front of my quad. So motor 1 is on the left front and the fourth is on the rear right of the drone. in iNav i'm trying to re map the motors via mixer Wizard and select props out config. After doing that the ESC keeps beeping (not continosly but once after time) and the motors aren't in right config of props out, so the motor in the front left is props out but the one in front right spin props in, so in the rear.
I also noticed that after the flash in iNav esc configuratore doesn't read my ESC anymore (it says ESC 1,2,3,4 failed to read) this didn't happen with betaflight flashed.
my specs: ESC DAKEFPV 4 in 1 70A, FC DAKEFPV H743, motors R3115 900KV.