Hello,
Thanks for your work on the coding to allow Arduino to communicate with the MaxDome II protocol. I am having issues getting this to work. I recently installed The Sky X and the MaxDome II X2 driver; however, I keep getting an error that the Arduino is not responding. I can see the Rx light blinking when I try to connect as does the Built-in LED. I was wondering if perhaps the driver I am using had been updated so that it is not compatible with your code.
Also, I noted the maxdomeii.py file - is there something specific I should do with that? I am on Mac Ventura and am directly uploading the code via the Arduino IDE instead of makefile.
Hello,
Thanks for your work on the coding to allow Arduino to communicate with the MaxDome II protocol. I am having issues getting this to work. I recently installed The Sky X and the MaxDome II X2 driver; however, I keep getting an error that the Arduino is not responding. I can see the Rx light blinking when I try to connect as does the Built-in LED. I was wondering if perhaps the driver I am using had been updated so that it is not compatible with your code.
Also, I noted the maxdomeii.py file - is there something specific I should do with that? I am on Mac Ventura and am directly uploading the code via the Arduino IDE instead of makefile.