Repository navigation
Meteo and Hydro messages not decoding #597
|
There are six locations within my view which apparently send meteo/hydro data (Binary Msg 8, DAC 1, FID 31), but when I inspect the red icons on the map there is no content except for metadata about the transmission and location. Any ideas on why these messages are failing to decode and if it is reasonably expected that AIS-catcher would do so? Attached are some samples for your analysis. Thanks for the help. Regards, Mike |
Replies: 2 comments 1 reply
|
All the data in these messages is set to "Undefined", so probably sensors are not working? Question what we should do with these messages visually. Perhaps do not show them.... |
|
For messages without any sensor data, I will not include them in the map anymore to avoid clutter. |
|
Thanks for looking into this. Some of these locations have been sending data like this for a very long time so I would have thought those responsible would have noticed it and either fixed the issue or turned it off. Maybe I am expecting too much ... Agree that removing these messages from the map helps cut down on the clutter. |
For messages without any sensor data, I will not include them in the map anymore to avoid clutter.