-
check index_BOM.html, look for duplicates (different names going to the same description), change it in the doc to de-duplicate it.
-
Predrill of Top plexiglass plates: distances are different from earlier version: need a check. + give distance in absolute value too (in the text).
-
check value for Predrill long sides and make a drawing.
-
side_plates.jpg is wrong, rewrite description to fit the other one (Predrill short sides)
-
explain difference in hole size (2,3,5,8 ?)
-
Airtable part 3: Glueing and screwing: add photo of result
-
tell which side should be the holes (the one 10 mm from the border)
-
[Connect the air table box and the U-formation framework with two M5x12mm screws from the inside of the air box in each nut: Does it need to be air tight ?
-
there are 4 holes, but you speak of 2 nuts ??
-
Glue bottom plate gets 2 entries ?
-
Step 3: Attach a second frame circle: photo does not have the extra horizontal sturt used for the camera. Is it needed for stability? If not, I would put it in the camera fixing chapter.
Incoming air and pressure control : NOT WORKING
- would it be better to predrill ?
- in any case drilling should be done before gluing the bottom part !!
pixie camera:
3d files should have holes. or give alternative using any piece of plastic found around ?
Construction of the linear actuator front: should it not be part of reward system ?
sometimes, things may be simplified, see d7cd7c1
check index_BOM.html, look for duplicates (different names going to the same description), change it in the doc to de-duplicate it.
Predrill of Top plexiglass plates: distances are different from earlier version: need a check. + give distance in absolute value too (in the text).
check value for Predrill long sides and make a drawing.
side_plates.jpg is wrong, rewrite description to fit the other one (Predrill short sides)
explain difference in hole size (2,3,5,8 ?)
Airtable part 3: Glueing and screwing: add photo of result
tell which side should be the holes (the one 10 mm from the border)
[Connect the air table box and the U-formation framework with two M5x12mm screws from the inside of the air box in each nut: Does it need to be air tight ?
there are 4 holes, but you speak of 2 nuts ??
Glue bottom plate gets 2 entries ?
Step 3: Attach a second frame circle: photo does not have the extra horizontal sturt used for the camera. Is it needed for stability? If not, I would put it in the camera fixing chapter.
Incoming air and pressure control : NOT WORKING
pixie camera:
3d files should have holes. or give alternative using any piece of plastic found around ?
Construction of the linear actuator front: should it not be part of reward system ?
sometimes, things may be simplified, see d7cd7c1