Multi ESP32 signals not fused

[Ying-Kai-Liao]

I prepared 3 ESP32-S3, connected to AP from raspberry pi, and host the aggregator (main server) on the pc. Can receive signals from different node ids but not triggering any kind of signal fusion and fail to detect people count/ pose at all. Barely can say the signal is changing while moving (vitals) but nothing about position / pose is working.

trim.DFF94B10-0DA2-428E-A846-799CA996297E.MOV

[JarrodLambert]

I'm having a similar issue!

[ak1ca1]

Same

[Leeeeeeedw]

I also setup 3 ESP32-S3, and config with "python firmware/esp32-csi-node/provision.py --port COM7 --ssid "YourWiFi" --password "YourPassword" --target-ip 192.168.1.20 --node-id 1" command, but when I use the aggregator to listen the data, it will receive data from 3 different IP but same node_id 1. Do you know why? Or how do you config the node-id?

[Velociraptor85]

the rust log prefix is mentioned in #334 (comment)

I could not find the reference to the esp monitoring command but it was essentially idf port monitor

But since you already flashed three different esps I would reflash it and provision again with the node id option.

[Leeeeeeedw]

Thanks!

I already reflash and provision with the "node-id" option today, but it didn't work finally, I don't know how to fix this problem...

[panscamera]

I'm also having a similar issue on mac. Nodes have their ids set, I've flashed and re-flashed multiple times, but nothing

[Leeeeeeedw]

Maybe you can use v0.5.1 or v0.5.3 to have a try, I can config with these two version

[panscamera]

no luck with 0.5.3, I'll try with 0.5.1 in a bit but I'm starting to wonder if it's an issue with the rust sensing server

[ISlamMah]

I also have the same issure where i flashed 4 nodes with different node id but when i listen to them using nodes endpoints i found only one node id sending data, did you guys found any solution?