Watchy Armadillonium case + Leatherman Tread (LT)

[shtrom]

This is not an issue per se, but I wanted to record this somewhere, in case others are after this.

I have found a way to use a Leatherman Tread (LT) as the wristband for an Armadillonium case. tl;dr: not an exactly perfect fit, but it works.

I found some adapters on AliExpress. There are many options (including many knock-off Treads), but I lucked out on my first try with the following:

• https://www.aliexpress.com/item/4001012613514.html?spm=a2g0o.order_detail.0.0.7b32f19cCVEXDa
• For 2.45cm Bracelet
• For 24mm Watch

It mostly works, however:

• The links fit very very tightly in the case. The little holes for the springs could not be any further in, or any closer to the back of the case. Actually, it is so tight that it's impossible for the link to be fully flat with the back of the case, but this is not an issue when wearing the watch.
• The 2.45cm width does NOT actually match the Leatherman Tread LT links. They are ~18mm wide, but this was not an option for this particular set of links. Fortunately, the attachments still fit, but there's a bit of wobble (which can probably be addressed with small washers), and the screws cannot go all the way into the link. This makes the attachment of the link a bit stiff. However, once again, it's not an issue when wearing the watch.