Evaluate LCD library

[archerindigo]

Evaluate LCD library to see how to control image displays.

May break this issue into smaller issues.

[archerindigo]

@wjb321 May you set some smaller goals regarding the development of the HoloCube software and update the progress from time-to-time?

[wjb321]

I will set several subgoals and put them below.

[archerindigo]

You should create new issues when you set your sub-goals. Better fit a week of workload for each task.

[wjb321]

there are some basic tasks that I did in local disk about LCD（lvgl） and recently I will upload the local notes and update the tasks below:

1. [ ]vscode environment and esp-idf environment setup
2. [ ]esp32 examples tests and peripheral test
3. [ ]lvgl display interface and GUI library porting
4. [ ]lvgl animation test and coding
5. [ ]2048 game + BLE control(partition table error: more than1mb error 102% problem)

[wjb321]

1. vscode environment and esp-idf environment
   a, first time i tried on mac by using vscode_mac, but can not upload to board, it may be caused by driver problems or Type-c port problem. I can build but can not upload
   b, vscode environment here is my reference vscode_win this works fine.
   c, esp-idf, there were many problems. by checking the manual, i stalled the esp-idf tools installer(esp-idf power shell, cmd and eclipse) and then all the configurations for changing the layout and size should configure by some commands, somehow not so convenient for me. as an alternative, i found the the support plug-ins in the vscode, then i searched them and installed. then the problems happened with the environment variables conflicts, vscode esp-idf can not find some paths and files even i added in the path josn. but finally worked when reinstall the plugs-ins and make a fixed environment variables(can not share with original variables)
   d, tested some given examples in the Soc

[wjb321]

e, sometimes building a esp-idf project in vscode, the menuconfig will stop in initial values state forever :(, for solving this issue, it took quite a long time to solve, the final solutions were either make sure the repository esp-idf is the same root directory in the file or need configure the environment path.
f, the project opened in vscode can not be second level dir, it will make build file in the same level with the project, then the menuconfig will stop at loading initial variables forever again.
g, when esp-idf is in the same file, the example sub-file can be deleted, somehow can make the building time shorter

h, esp-idf building steps esp-idf-soc