Skip to content

Hardware used

Jump to bottom
Fizzy edited this page Sep 4, 2024 · 2 revisions

Since FT Enderwire has been opened up for upgraded parts the hardware used for my own build varies of that from a standard conversion. Below is a list of all the key hardware components required to build: -

  1. 5 x MGN12H 300mm linear rail with block
  2. 3 x 20 Teeth 2GT pulley
  3. 2 x GT2 Open Belt LL-2GT-6 (6mm wide) - 1500mm
  4. GT2 Open Belt LL-2GT-6 (6mm wide) - 800mm
  5. 20 x F695 2RS Bearing
  6. 3 x NEMA17 Motor (LDO 42STH40-1684AC or Stepperonline 17HS15-1504S1 recommended). Original Ender 3 Steppers can also be reused but the preinstalled pulleys will need to be carefully removed.
  7. 4 x Rubber Compressor Feet

For more info join our Discord

Introduction
Preparing to build
Building FT Enderwire

Clone this wiki locally